Final design board

In this post, I will talk about my board creation process using my drawings and the website, called Canva I used to create them. 

Front Elevation

Rear Elevation

First, for my evaluations, I did my drawing on paper using a light board and the printed image of the outline of my 3D model I made using SketchUp. After outlining with an ink pen, I scan the drawing and add the dimensions using the lines from Canva. To the board, I also added my logo and the name of my project. 

After I had to do my section board, my brief only mentioned one elevation, and as it was my first time doing one, I only wanted to experiment with one possible bad outcome.  For this, I used the same process as my evaluations. I used one image of the 3D model I made and drew it usingan  ink pen. I later scanned it and added it to a page on Canva, where I added the dimensions and the line to specify these dimensions.

For my 3D outcome board, I used two pictures per board and added the scale for my model and the logo I had already created.

For my site board, I added the measurements of the site using the same elements as the rest of the boards and added the image of the site as well as the description of it.